NXP Semiconductors MPC5606S - Programming for Debug Mode

Display Control Unit (DCU)
MPC5606S Microcontroller Reference Manual, Rev. 7
436 Freescale Semiconductor
12.7.3 Programming for Debug mode
1. Program the only debug layer as FG layer. No layer is programmed as BG layer.
2. Set startX, Starty, WIDTH, and LENGTH as full layer parameters.
3. Set Safety mode to 1.
4. Check the CRC when CRC calculation interrupt is raised for a particular screen.
12.7.4 Programming of Tag mode
1. Program the safety layers.
2. Set startX, Starty, WIDTH, and LENGTH as full layer parameters.
3. Set Tag bit to 1.
4. Set Program Safety mode to 1.
5. Check the CRC when CRC calculation interrupt is raised fora particular screen.
12.8 Parallel Data Interface (Camera Interface)
Figure 12-79. Camera interface block diagram
Part 0 All the parameter have value other the one
mentioned above as shown in
Figure 12-77
Safety Layer
(Layer 0 and 1 only)
1 Part of the safety Layer would depend on
• Part lying within the area of concern
defined by the StartX startY LenX LenY
• Part deleted by the chroma keying
functionality
Table 12-64. Supported Area (continued)
Area Tag Value Note
Video
DCU
Display
Digital
RGB/Mono/YCbCr
Digital
Digital
Digital
RGB/Mono/YCbCr
RGB
RGB
DCU
Display
FPGA
CCIR656
RGB
Proprietary
LVDS
source