LIN Controller (LINFlex)
MPC5606S Microcontroller Reference Manual, Rev. 7
Freescale Semiconductor 879
23.8.3.2 Output compare mode
Resetting the LTOM bit in the LINTCSR enables the output compare mode. This mode allows the user to
fully customize the use of the counter.
OC1[0:7] and OC2[0:7] output compare values can be updated in the LINTOCR by software.
23.8.4 Interrupts
Table 23-33. LINFlex interrupt control
Interrupt event Event flag bit Enable control bit Interrupt vector
Header Received interrupt HRF HRIE RXI
1
1
In Slave mode, if at least one filter is configured as TX and enabled, header received interrupt vector
is RXI or TXI depending on the value of identifier received.
Data Transmitted interrupt DTF DTIE TXI
Data Received interrupt DRF DRIE RXI
Data Buffer Empty interrupt DBEF DBEIE TXI
Data Buffer Full interrupt DBFF DBFIE RXI
Wake-up interrupt WUPF WUPIE RXI
LIN State interrupt
2
2
For debug and validation purposes
LSF LSIE RXI
Buffer Overrun interrupt BOF BOIE ERR
Framing Error interrupt FEF FEIE ERR
Header Error interrupt HEF HEIE ERR
Checksum Error interrupt CEF CEIE ERR
Bit Error interrupt BEF BEIE ERR
Output Compare interrupt OCF OCIE ERR
Stuck at Zero interrupt SZF SZIE ERR
To Next Page
Loading...
