EasyManua.ls Logo

NXP Semiconductors MPC5606S - Functional Ports

NXP Semiconductors MPC5606S
1344 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Signal Description
MPC5606S Microcontroller Reference Manual, Rev. 7
88 Freescale Semiconductor
3.8 Functional ports
The functional port pins are listed in Table 3-4.
TDO JTAG test data out M1 O Output,
None
34 39 N3
TMS JTAG test mode select S I Input, Pullup 35 41 M3
EVTI Nexus event input M1 I None, None 37 A11
EVTI Nexus event input M1 I Input, Pullup T3
EVTO Nexus event output M1 O None, None 35 D12
EVTO Nexus event output M1 O Input, Pullup R3
MCKO Nexus message clock output F O None, None 33 B12
MCKO Nexus message clock output F O Input, Pullup T1
MDO0 Nexus message data output 0 M1 O None, None 38 B11
MDO0 Nexus message data output 0 M1 O Input, Pullup T5
MDO1 Nexus message data output 1 M1 O None, None 40 C11
MDO1 Nexus message data output 1 M1 O Input, Pullup P5
MDO2 Nexus message data output 2 M1 O None, None 42 D11
MDO2 Nexus message data output 2 M1 O Input, Pullup P4
MDO3 Nexus message data output 3 M1 O None, None 44 A10
MDO3 Nexus message data output 3 M1 O Input, Pullup L4
MSEO Nexus message start/end output M1 O None, None 34 C12
MSEO Nexus message start/end output M1 O Input, Pullup T2
1
See note for dedicated pins for 208 MAPBGA package.
2
On the 176 LQFP package, the Nexus debug pins are multiplexed with other GPIO. The 208 MAPBGA package
provides dedicated Nexus debug pins as well as multiplexed Nexus debug pins. The multiplexing is described in the
port pin summary table.
3
On the 208 MAPBGA package, the dedicated Nexus debug output pins (MDO[0:3] and MSEO) may drive an
unknown value (high or low) immediately after startup but before the first clock edge propagates through the device,
instead of being weakly pulled low. This may cause high currents if the pins are tied to a supply/ground in the
application. If not used, these pins may be left unconnected.
Table 3-3. Debug pin descriptions (continued)
Debu
g
pin
Function
Pad
typ
e
I/O
directio
n
for
debug
RESET
config
1
Pin number
144 LQFP
176 LQFP
2
208 MAPBGA
Muxed
Dedi-
cated
3

Table of Contents

Related product manuals