NXP Semiconductors MPC5606S - C.5 Changes between Revisions 2 and 3

Revision History
MPC5606S Microcontroller Reference Manual, Rev. 7
Freescale Semiconductor 1335
C.5 Changes between revisions 2 and 3
Quad Serial Peripheral
Interface
Revised the “Debug Mode (SPI Modes Only)” section.
Revised the “Signal properties” table.
Revised the QSPI_MCR[FRZ] field description.
Revised the QSPI_SFAR section.
Safety Revised the “Modes of operation” section.
Changed “AIPS” to “PBRIDGE”.
Revised the SWT_CR section.
In the SWT section, added the “SWT operation timing diagram” figure and the “SWT
operation after reset” figure.
In the SWT section, revised the “Features” section.
System Status and
Configuration Module
Revised the MEMCONFIG[IVLD] field description.
Wakeup Unit Revised the “Wakeup vector mapping” table.
Added a note about pin termination to the “External signal description” section.
In the register figures, changed “[19:0]” to “[20:0]”.
Real-Time Clock Revised the clock names to be consistent with the rest of the document.
Revised the RTCS figure.
Restructured the “Modes of operation” section and revised the debug information therein.
Revised the RTCC[FRZEN] field description.
Voltage Regulators and
Power Supplies
Revised the “Power supply configuration” figure.
In the “Power domain organization” figure, changed “RAM Domain 2 (RD2)” to “Power
Domain 2 (PD2)”.
Revised the “Voltage regulators” section.
In the “VDDR” section, changed “This pin should have an external decoupling capacitor of
the order of 10 to 100 nF” to “See the device data sheet for details of recommended
decoupling capacitance on this pin”.
In the “High Power or Main Regulator (HPREG)” section, deleted “The minimum
recommended value is 600 nF with low ESR. Limit the series inductance per pad to less
than 15 nH.”.
Appendix B Changed register names as follows:
• iFLAG1 to IFRL
• iFLAG2 to IFRH
• iMASK1 to IMRL
• iMASK2 to IMRH
Table C-5. Changes between revisions 2 and 3
Chapter Description
Throughout Editorial changes and improvements.
Overview In the Introduction section, changed “Up to 8 modulus counter” to “Up to 5 modulus
counters”.
In the Introduction section, changed “Peripheral Interrupt Timer” to “Periodic Interrupt
Timer”.
Table C-4. Changes between revisions 3 and 4 (continued)
Chapter Description