NXP Semiconductors MPC5606S - Short-Circuit Detector Interrupt Enable Register 2 (MCSDIEN2)

Stepper Motor Controller (SMC)
MPC5606S Microcontroller Reference Manual, Rev. 7
1134 Freescale Semiconductor
35.3.2.12 Short-circuit Detector Interrupt Enable Register 2 (MCSDIEN2)
35.3.2.13 Short-circuit Detector Interrupt Register 0 (MCSDI0)
Offset Module Base + 0x004A
0 1 2 3 4 5 6 7
R
SDIE
W
Reset 0 0 0 0 0 0 0 0
Figure 35-13. Short-circuit Detector Interrupt Enable Register 2 (MCSDIEN2)
Table 35-15. MCSDIEN2 field descriptions
Field Description
SDIE Short-Circuit Detector Interrupt Enable — The interrupt of each short-circuit detector can
individually be enabled or disabled according to the mapping described in Tabl e 35-23. The
short-circuit detector interrupt of a given pin is enabled if the related interrupt enable bit is set to 1.
Offset Module Base + 0x004C
0 1 2 3 4 5 6 7
R SDIF
W rwm rwm rwm rwm rwm rwm rwm rwm
Reset 0 0 0 0 0 0 0 0
Figure 35-14. Short-circuit Detector Interrupt Register 0 (MCSDI0)
Table 35-16. MCSDI0 field descriptions
Field Description
SDIF Short-circuit Detector Interrupt Flag — In case of a detected short-circuit, the corresponding bit
according to the mapping in
Tabl e 35-23 is set in the short-circuit detector interrupt register.
If this specific interrupt is also enabled in the interrupt enable register MCSDIEN0, than this event will
rise an external interrupt.