NXP Semiconductors MPC5606S - LIN Output Compare Register (LINOCR)

LIN Controller (LINFlex)
MPC5606S Microcontroller Reference Manual, Rev. 7
Freescale Semiconductor 851
23.7.2.8 LIN output compare register (LINOCR)
23.7.2.9 LIN timeout control register (LINTOCR)
Address: Base + 0x001C Access: User read/write
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
R 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
W
Reset 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31
R
OC2[0:7]
1
OC1[0:7]
1
W
Reset 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1
1
If LTOM in the LINTCSR register is set, these bits are read-only.
Figure 23-14. LIN output compare register (LINOCR)
Table 23-13. LINOCR field descriptions
Field Description
0:15 Reserved
OC2[0:7]
16:23
Output compare 2 value
These bits contain the value to be compared to the value of bits CNT[0:7] in LINTCSR.
OC1[0:7]
24:31
Output compare 1 value
These bits contain the value to be compared to the value of bits CNT[0:7] in LINTCSR.
Address: Base + 0x0020 Access: User read/write
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
R 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
W
Reset 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31
R 0 0 0 0
RTO[0:3]
0
HTO[0:6]
W
Reset 0 0 0 0 1 1 1 0 0 0 * * 1 1 0 0
*: These bits reset to 10 for LINFlex_0 and 01 for LINFlex_1.
Figure 23-15. LIN timeout control register (LINTOCR)