NXP Semiconductors MPC5606S - Page 918

Mode Entry Module (MC_ME)
MPC5606S Microcontroller Reference Manual, Rev. 7
916 Freescale Semiconductor
This register allows a way to disable the device modes which are not required for a given device. Reset,
Safe, DRUN, and Run0 modes are always enabled.
Table 25-6. Mode Enable Register (ME_ME) field descriptions
Field Description
STANDBY Standby mode enable
0 Standby mode is disabled
1 Standby mode is enabled
STOP Stop mode enable
0 Stop mode is disabled
1 Stop mode is enabled
HALT Halt mode enable
0 Halt mode is disabled
1 Halt mode is enabled
RUN3 Run3 mode enable
0 Run3 mode is disabled
1 Run3 mode is enabled
RUN2 Run2 mode enable
0 Run2 mode is disabled
1 Run2 mode is enabled
RUN1 Run1 mode enable
0 Run1 mode is disabled
1 Run1 mode is enabled
RUN0 Run0 mode enable
0 Run0 mode is disabled
1 Run0 mode is enabled
DRUN DRUN mode enable
0 DRUN mode is disabled
1 DRUN mode is enabled
SAFE Safe mode enable
0 Safe mode is disabled
1 Safe mode is enabled
TEST Test mode enable
0 Test mode is disabled
1 Test mode is enabled
RESET Reset mode enable
0 Reset mode is disabled
1 Reset mode is enabled