Revision History
MPC5606S Microcontroller Reference Manual, Rev. 7
Freescale Semiconductor 1327
Configurable
Enhanced Modular IO
Subsystem
(eMIOS200)
ERR003305:
— Removed GTBE bit from the “eMIOS200 Module Configuration Register
(EMIOSMCR)” figure.
— Removed GTBE graphical content from the “eMIOS200 Full Channel Configuration
using Unified Channels only” figure.
— At end of the “Input Programmable Filter (IPF)” section, changed sentence “The filter
is not disabled during either freeze state or negated GTBE input.” to “The filter is not
disabled during freeze state.”
— At end of the “Clock Prescaler (CP)” section, changed sentence “The filter is not
disabled during either freeze state or negated GTBE input.” to “The filter is not disabled
during freeze state.”
— At end of the “Global Clock Prescaler Submodule (GCP)” section, changed sentence
“The filter is not disabled during either freeze state or negated GTBE input.” to “The filter
is not disabled during freeze state.”
— At end of the “Channel/Modes Initialization” section, removed final item in numbered
list, “15. [global] Enable Global Time Base.”
Deserial Serial
Peripheral Interface
(DSPI)
In the “Clock Polarity Switching between DSPI Transfers” section, added NOTE:
(ERR003105)
In the “Continuous Serial Communications Clock” section, replaced the first bulleted list
(ERR000575, ERR001103)
DMA Channel Mux
(DMACHMUX)
In “DMACHMUX request assignments” table, set request #53 to “reserved.”
Error Correction Status
Module (ECSM)
Corrected “AIPS” to “PBRIDGE.”
Corrected “AXBS” to” XBAR.”
Flash Memory ERR003114:
— In “ADR field descriptions” tables (two places), added NOTE: to AD bit field
FlexCAN ERR002360:
— Added text to the “Rx Global Mask (RXGMASK)” section above the “Rx Global Mask
Register (RXGMASK)” figure describing bit mask mis-alignment.
— Added cross-reference in the “Rx 14 Mask (RX14MASK)” section to the new text
added in the “Rx Global Mask (RXGMASK)” section
— Added cross-reference in the “Rx 15 Mask (RX15MASK)” section to the new text
added in the “Rx Global Mask (RXGMASK)” section
IEEE 1149.1 Test
Access Port Controller
Added NOTE: at the end of the “External signal description” section (ERR003116)
Interrupt Controller
(INTC)
Corrected abbreviation of WakeUp Unit module to WKPU.
Mode Entry Module
(MC_ME)
In the “Interrupt Status Register (ME_IS) field descriptions” table, added NOTE: to I_ICONF
bit field: “The I_ICONF bit will not detect that modes that select a PLL to be active also
have the FXOSC enabled. Therefore, always ensure that any mode that selects PLL as
the system clock also has the associated FXOSC bit set.” (ERR003202)
Added NOTE: at end of the “SAFE Mode” section (ERR003094)
Added NOTE: at end of the “HALT Mode” and “STOP Mode” sections (ERR003190)
Table C-2. Changes between revisions 5 and 6 (continued)
Chapter Description
To Next Page
Loading...
