Revision History
MPC5606S Microcontroller Reference Manual, Rev. 7
Freescale Semiconductor 1331
Signal Description Changed several pin names (primarily those that contained _A, _B, _C, ...; they now contain
_0, _1, _2, ... ).
In the “Port pin summary” table, added a footnote to the “Special function” column.
Clock Description Revised the “MPC5606S system clock generation” figure.
In the “Truth table of crystal oscillator” table, changed “ENABLE” to “OSCON” and “BYP” to
“OSCBYP”.
Revised the note in the “32 kHz OSC digital interface” OSC_CTL register description.
Deleted the S_RC_STDBY field from the RC_CTL register (not present on this device).
In the FMPLL section, changed “SSCG” to “FM”.
In the FMPLL section, added notes that the maximum value of MODPERIOD is 0x1000.
Mode Entry Module In the “STANDBY Mode” section, changed “The only parts of the device that are still
powered...” to “By default the only parts of the device that are still powered...”.
Changed the ME_HALT_MC[MVRON] field from read-only to read/write.
Changed the ME_STOP_MC[FIRCON] field from read/write to read-only.
Changed the ME_STANDBY_MC[FXOSCON] field from read-only to read/write.
Revised the “MC_ME resource control overview” table.
Boot Assist Module Deleted the FlexRay-related footnotes in the Overview and “Boot Modes” sections.
DMA Channel Mux In the “DMACHMUX request assignments” table, changed the following:
IIC_A_TX to I2C_0_TX
IIC_A_RX to I2C_0_RX
IIC_B_TX to I2C_1_TX
IIC_B_RX to I2C_1_RX
IIC_C_TX to I2C_2_TX
IIC_C_RX to I2C_2_RX
IIC_D_TX to I2C_3_TX
IIC_D_RX to I2C_3_RX
Crossbar Switch Renamed AIPS to PBRIDGE.
Revised the “Debug mode” section.
AIPS Changed the chapter name to “Peripheral Bridge” and the module abbreviation to
“PBRIDGE”.
Table C-4. Changes between revisions 3 and 4 (continued)
Chapter Description
To Next Page
Loading...
