Revision History
MPC5606S Microcontroller Reference Manual, Rev. 7
Freescale Semiconductor 1341
I
2
C Module Added the “Modes of operation” section.
Added the IBCR[DMAEN] field.
Added the “DMA application information” section.
Configurable
Enhanced Modular IO
Subsystem
Changed “eMIOS200_A” to “eMIOS200_0” and “eMIOS200_B” to “eMIOS200_1”.
Added device-specific information.
Changed some clock and signal names for consistency.
In the block diagram:
• Changed CH[27] to CH[23]
• Changed ipp_obe_emios_ch[27] to ipp_obe_emios_ch[23]
• Changed EMIOSO[27] to EMIOSO[23]
• Changed EMIOSI[27] to EMIOSI[23]
• Changed emios_flag_out[27] to emios_flag_out[23]
• Changed the interface signal names.
Removed references to non-existent counter bus E.
Revised the “UC ODISSL selection” table.
Changed “Shadow FLAG register” to “Global flag register”.
Deleted information about the following non-existent modes:
• Input Pulse Width Measurement
• Input Period Measurement
• Double Action Output Compare
• Pulse/Edge Accumulation
• Pulse/Edge Counting
• Quadrature Decode
• Windowed Programmable Time Accumulation
• Modulus Counter
• Output Pulse Width and Frequency Modulation
• Center Aligned Output Pulse Width Modulation with Dead Time Insertion (normal and
buffered)
• Output Pulse Width Modulation
• Output Pulse Width Modulation with Trigger
Deleted information about the non-existent Wheel Speed Channel.
Changed bit 0 in the EMIOSMCR (was DOZEEN, is reserved).
In the “Functional Description” sections, deleted all channels above 23.
Analog-to-Digital
Converter
Replaced the entire chapter.
Display Control Unit Replaced the entire chapter.
Sound Generation
Logic
Changed the description of the “pwm_ch0 to pwm_ch15” signals.
Revised the SGL_STATUS register figure.
In the “Monophonic sound” section, changed “fixed pulse width” to “fixed duty cycle”.
In the “Polyphonic sound” section, changed “a given frequency” to “the PCM sample
frequency” and added the following text:
The output must be filtered by a low-pass filter. The quality and the order of the low-pass
filter will have a direct impact on the quality of the produced sound.
LCD Driver Corrected the number of front and back planes.
Quad Serial Peripheral
Interface
Added information about the QuadSPI module.
Safety Updated the SWT_CR figure to reflect that this device has only 4 masters.
Table C-6. Changes between revisions 1 and 2 (continued)
Chapter Description
To Next Page
Loading...
