Omron fh-3 series - Region Setting (Circular Scan Edge Position)

Circular Scan Edge Position
270
FH/FZ5 Processing Item Function Reference Manual
Region Setting (Circular Scan Edge Position)
This item is used to set up the measurement area.
Specify the measurement region for [Circular Scan
Edge Position] by using circular shapes.
1 In the Item Tab area, click [Region setting].
2 Use the Drawing tools to specify the measurement region.
To align with the measurement area and
specify the measurement point again,
uncheck "Fix region count".
3 Click [OK] in the Figure setting area.
• [OK]: Changes the settings and returns to the previous menu.
• [Cancel]: Changes are discarded. R
eturns to the previous menu.
• [Apply]: Updates the settings without leaving edit window.
4 Specify the method of measurement, the
measurement point, and the start angle
for the region.
5 Set the mask size for the region.
Setting item
Set value
[Factory default]
Description
Direction
•[Out→In]
•I
n→Out
Set the measurement direction.
Scan sub-region
Set the measurement point.
Use either the "Divide num" or the "Divide angle" for this
setting.
Divide number
3 to 360
[4]
Set the number of divisions for the circle.
The specified value is used as the measurement point.
Angle number
1.000 to 179.999
[90.000]
Set the skipping angle for the circle.
The measurement point is determined based on the specified
a
ngl
e.
Start angle
0 to 359
[0]
Set the start angle to specify a region.
Setting item
Set value
[Factory default]
Description
Mask size
0 to 1000
[10]
Set the filter size when smoothing the measurement point vicinity. When 5
is
set, smoothing is processed for a total of 11 points: the measurement
point and the 5 pixels before and after it.