Focus
692
FH/FZ5 Processing Item Function Reference Manual
Focus
This function helps you bring the camera into focus.
Used in the Following Case
• Use this function to make adjustments so as to facilitate inspection of input images that tend
to become out of focus.
Measurement Parameters (Focus)
Measurement parameters can be changed as needed to address unstable focus values.
1 In the Item Tab area, click [Measurement].
2 In the "Display" area, click [Change display] to switch between camera image types.
(Re-measurement images are not shown on the setting window.)
• Processing is different for color images and monochrome images. If the camera type, color camera, or monochrome
camera, was changed from a previous setup, a reset of some settings may be needed.
Setting item Set value Description
ON
Through The latest image is always input from the camera and displayed.
Freeze
The image that was scanned in the immediately preceding
mea
s
urement is displayed.
focus has shifted due to change in the height of the target work, etc., adjust the focus.
Before processing After processing
To Next Page
Loading...
Need help?
General
