EasyManua.ls Logo

Omron fh-3 series - Intersection; Settings Flow (Intersection)

Omron fh-3 series
904 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Intersection
292
FH/FZ5 Processing Item Function Reference Manual
Intersection
This processing item measures a corner position (corner) of a work.
Calculate approximate lines from the edge information on
two sides of a square work to measure the angle
formed at the intersection of the two lines.
Used in the Following Case
When you want to align the work position based on the feature of its corner
Settings Flow (Intersection)
Follow the steps below to set up intersection coordinates.
Processing is different for color images and monochrome images. If the camera type, color camera, or monochrome
camera, was changed from a previous setup, a reset of some settings may be needed.
Important
Make sure to set Set as necessary.
Check results/make adjustments
Region Setting (Intersection)
Start
Measurement Parameters (Intersection)
Judgement Condition (Intersection)
Settings complete
Test measurement
Reference Setting (Intersection)
Output Parameters (Intersection)
Edge Color Specification (Intersection)

Table of Contents

Related product manuals