OCRFH/FZ5 Processing Item Function Reference Manual
471
2
Inspecting and Measuring
Click [Date update] to update the date information used for the verification characters.
Code Parameters (OCR)
Use this item to change code parameters.
For the code parameters, set the format of code characters used to measure coded dates.
Setting on the Screen
The setting procedure is explained below using the example of X as the code for October.
1 Click [Code parameter] in the Item Tab area.
2 Select the “Code month 1 flag”
checkbox.
3 In the code detail setting area, select the
“Code month 1 flag” checkbox.
Back margin 0 to 99 [0]
Set an appropriate count back time from the current time. Set in
unit
s of minutes.
Set this when the printing time is different from the inspection time.
Ahead margin 0 to 99 [0]
Set an appropriate count forward time from the current time. Set in
units of minutes.
Set this when the printing time is different from the inspection time.
• When a usage period is set, coded characters cannot be used in OCV.
Code month 1 and Code month 2
• Two code file patterns can be set to enable readiness for a setup change. Select the checkbox of the file to be
used.
Setting item
Setting value
[Factory default]
Description
To Next Page
Loading...
Need help?
General
