Advanced Filter
564
FH/FZ5 Processing Item Function Reference Manual
Settings Flow (Advanced Filter)
Set up advanced filter settings according to the following steps.
List of Advanced Filter Items
The following items can be set in advanced filter.
• Processing is different for color images and monochrome images. If the camera type, color camera, or monochrome
camera, was changed from a previous setup, a reset of some settings may be needed.
Item name Description
Filter setting
This function filters the image acquired fro
m the camera to make it easier to measure.
The filtering method can be selected as appropria
te for the image condition.
Reference: Filtering Settings (Advanced Filter) (p.565)
Region setting
Use this function to set, as the measurement area, the area on the image that you want to filter.
By narrowing the measurement region (as opposed to mea
suring the entire input image), this
function allows you to shorten the processing time.
Reference: Region Settings (Advanced Filter) (p.602)
Output image
Use this item to change th
e output image
settings.
These settings specify the image that is output a
s the measurement result. The image set as the
output image can be used as the measurement image on other processing units of the
measurement flow.
Reference: Output Image Settings (Advanced Filter) (p.603)
Necessary Steps Optional Steps
Check results/adjust parameters
▲
Filtering Settings (Advanced Filter)
Start
▲
Region Settings (Advanced Filter)
▲
Output Image Settings (Advanced Filter)
Settings completed
Test measurement
To Next Page
Loading...
Need help?
General
