Omron fh-3 series User Manual

Circular Scan Edge PositionFH/FZ5 Processing Item Function Reference Manual
271
2
Inspecting and Measuring
6 Perform the display setting if required.
Placing a check at [Filtered image] makes it
easier to change the filtering setting.
Edge Color Specification - For Color Cameras Only (Circular Scan Edge Position)
This item selects the color of the edges to be detected.
If the target color changes, this setting is not necessary.
If the color is not specified, positions in the
measurement region where the color changes drastically are detected as an edge.
1 In the Item Tab area, click [Edge color].
2 Place a check at "Edge color
specification" in the "Color setting" area.
3 This item selects the color to be detected as edges.
Setting item
Set value
[Factory default]
Description
Filtered image
•[Unchecked]
• Checked
If checked, the filtered image of the ranges
set with the Scan sub-region
and Filter size after smoothing is displayed.
• Enable or disable setting can be specified for each edge measurement number. Clicking edge
meas
urement points displays the following screen.
Item
Set value
[Factory default]
Description
Image Display area -
Specify a region on the image that includes the target color. The average
color of the
specified region is registered.
Color chart -
Click the reference color on the color chart to specify it. The RGB values
fo
r
the specified color are displayed at the bottom.
R, G, B
0 to 255
[255]
The color to be detected is se
t with the RGB val
ues.
Difference R, G, B
0 to 127
[5]
This sets the allowable color difference for detecting the edge, using the
specified co
lor as the reference. The larger the difference values, the
larger the color range that is used to detect the edge.
Detection mode
• [Color IN]
•Color OUT
Color IN: The position where a color other than the specified color
chang
es to the specified color is detected as the edge.
Color OUT: The position where the specified color changes to a color
other th
an the specifie
d color is detected as the edge.
Note
Start
point
For “Color IN” edge
measurement mode
End
point
Start
point
For “Color OUT” edge
measurement mode
End
point

Omron fh-3 series Specifications

General

Brand	Omron
Model	fh-3 series
Category	Accessories
Language	English