Fine MatchingFH/FZ5 Processing Item Function Reference Manual
385
2
Inspecting and Measuring
Measurement Parameters (Fine Matching)
This item specifies the judgement conditions for measurement conditions and measurement results.
1 In the Item Tab area, click [Measurement].
2 Select "Inspection" in the "Measurement
condition" area.
If "Binary area" is selected, the following operations are not necessary.
When Labeling is selected, the following items are set.
Setting item
Set value
[Factory default]
Description
Inspection
Images that are different from the model will be converted into binary images internally.
"Inspection" that is used to detect binary images should be selected.
[Binary area]
Defect is judged based on the total area of white pixels.
Labeling
A white pixel will be detected as 1 label, which is then compared with a
labe
l which is consistent with the set conditions to determine whether or
not it is a defect.
Item
Set value
[Factory default]
Description
Label No.
0 to 2499
[0]
Specify the label number used to determine
whether defects exist.
Different settings for "Sort condition" will lead to different number
assignme
nt.
Total area of
white pixels
1 defect (max area)
1 defect
1 defect
To Next Page
Loading...
Need help?
General
