Omron fh-3 series User Manual

Stripes Removal Filter II
536
FH/FZ5 Processing Item Function Reference Manual
Filter Setting (Stripes Removal Filter II)
This item sets the filter.
1 In the "Item Tab" area, click [Filter Setting].
2 In the "Display" area, click [Change
display] to switch between camera
image types.
The displayed contents of the image display
area will be switched.
3 Set the target image.
4 Set the correction method.
Setting item
Setting value
[Factory default]
Description
Display
Through image display The latest image is always input from the camera and displayed.
[Freeze image display]
The image that was scanned in the immediately preceding
measurement is displayed.
Filtered image
•[Checked]
• Unchecked
To display the original image, uncheck here.
Setting item
Setting value
[Factory default]
Description
Tar ge t
Camera image
The camera input image that has not b
een subject to filtering is
subject to compensation as is.
[Prev. unit image]
Images to which processing is applied in units even before the
"S
tripes Removal Filter II" being set are the targets.
Setting item
Setting value
[Factory default]
Description
Correction method
[Thick stripe off]
This item sets the filter size based on the size of the expected
defe
ct and removes the striped pattern.
Pinstripe off
This item sets the filter size based on the wid
th of th
e stripes and
removes the striped pattern.
• When this setting is changed, the filter se
tting and the detail setting will be reset to the factory default values.
Important

Omron fh-3 series Specifications

General

Brand	Omron
Model	fh-3 series
Category	Accessories
Language	English