Stripes Removal Filter IIFH/FZ5 Processing Item Function Reference Manual
537
3
Compensate image
5 This sets the filter settings.
6 Set the details.
Correction method: For "Thick stripe off"
Setting item
Setting value
[Factory default]
Description
Direction
• [Normal]
• Vertical
• Horizontal
• Upper right
• Lower right
Specify the filter direction.
Filter Size
3 to 63
[3]
The value is set based on the size of the
defect to be extracted or
the size of the stripes. Only an odd number value can be specified.
For "Pinstripe off":
Select a filter size larger than the width of the striped pattern.
For "Thick stripe off":
Select a filter size larger than the size of the defect to be detected.
Setting item
Setting value
[Factory default]
Description
Defect brightness
• [Light and darkness]
• Light
• Darkness
Set the brightness of defects to be extracted from the background.
To
detect both white defects and black defects, select "Light and
darkness".
Gain
1 to 63
[1]
Adjust the contrast of an ima
ge after the pattern suppression.
Specifying a larger value emphasizes the density differences
with
in the image.
Offset
0 to 255
[128]
Adjust the brightness of an image af
ter the pattern suppression.
Specifying a larger value increases the brightness of the image.
To Next Page
Loading...
Need help?
General
