Omron fh-3 series - Page 546

Trapezoidal Correction
544
FH/FZ5 Processing Item Function Reference Manual
3 Set the reference position.
When Operation is chosen
Click [Edit].
Click [...] and set the expression.
Reference: Layout of Setting Expression
Window (p.621)
4 Set the measure position.
5 Set the display settings as necessary.
Setting item
Set value
[Factory default]
Description
Setting method
• [Figure]
• Operation
Set the method for setting the reference position.
When fixed value is selected, specify the
vertex position on the
image.
After setting with an expression, if the setting is changed to a fixed
val
ue, the
result of the expression is reflected as a fixed value.
Setting item
Set value
[Factory default]
Description
Setting method
• [Figure]
• Operation
Set the method for setting the measurement position.
When fixed value is selected, specify the
vertex position on the
image.
After setting with an expression, if the setting is changed to a fixed
val
ue, the
result of the expression is reflected as a fixed value.