Omron fh-3 series - Page 662

Get Unit Figure
660
FH/FZ5 Processing Item Function Reference Manual
Figure N data 00 to 20
(N = 0 to 9)
FND 00 to FND 20
• For ellipses
0: X coordinate for center point
1: Y coordinate for center point
2: Radius in X direction
3: Radius in Y direction
• For circles
0: X coordinate for center point
1: Y coordinate for center point
2: Radius
• For wide circles
0: X coordinate for center point
1: Y coordinate for center point
2: Radius
3: Width
•For arcs
0: X coordinate for center point
1: Y coordinate for center point
2: Radius
3: Start angle of arc
4: End angle of arc
• For wide arcs
0: X coordinate for center point
1: Y coordinate for center point
2: Radius
3: Start angle of arc
4: End angle of arc
5: Width
• For polygons
0: Number of vertexes
1: X coordinate for vertex 0
2: Y coordinate for vertex 0
3: X coordinate for vertex 1
4: Y coordinate for vertex 1
5: X coordinate for vertex 2
6: Y coordinate for vertex 2
:
:
19: X coordinate for vertex 9
20: Y coordinate for vertex 9
Set to 0 if disabled or no figures are acquired.
Measurement items Character string Description