Flexible Search
112
FH/FZ5 Processing Item Function Reference Manual
3 Use the drawing tools to specify the model registration range.
4 Click [OK] in the Figure setting area.
• [OK]: Changes the settings and returns to
the previous menu.
• [Cancel]: Changes are discarded. Returns to
the previ
ous me
nu.
• [Apply]: Updates the settings without leaving
edi
t win
dow.
5 To register two or more models, repeat
the Steps Reference: 2 (p.111) to
Reference: 4 (p.112).
Changing Model Parameters
Model parameter values can be changed as needed to address unstable measurement results or to increase the
processing speed. Normally, the factory default value will be used.
After changing a setting, re-register the model.
1 In the "Model parameter" area, select the
search mode, then specify a value for
each item for that mode.
• When a model is registered, the center of the model is registered
as the detection point. A detection point is a point output as a
measurement value. If multiple figures are combined, the central
coordinates of the circumscribed rectangle are registered.
Setting item
Set value
[Factory default]
Description
Search mode
[CR]
Search for normalizing the brightness. This method can provide stable
me
asuremen
t when there is fluctuation in the overall brightness and when the
image has low contrast.
PT
Measures the degree of matching with the
model profile. This method can
measure at higher speed when the rotation angle has a wide range.
It is available only when a 0.3 megap
ixel
color camera is connected.
Model
Detection coordinate
Can be changed to an appreciate position.
To Next Page
Loading...
