Omron fh-3 series - Page 203

Ec CornerFH/FZ5 Processing Item Function Reference Manual
201
2
Inspecting and Measuring
*1: The reference coordinates based on the selection in the Method area of the [Ref.setting] tab can be Get only.
*2: The reference coordinates based on the selection of Numerical in the Method area of the [Ref.setting] tab can be Set/Get.
173
Reference unit number for
refe
rence coordinate
Set/Get -1 to 9999
174
Reference type of reference
co
ordin
ate
Set/Get
0: Set by number
1: Unit reference
176
Use coordinates before
position compensation
Set/Get
0: Not used
1 : Used
177
Coordinate X before position
co
mpensation
Set/Get -99999.9999 to 99999.9999
178
Coordinate Y before position
co
mp
ensation
Set/Get -99999.9999 to 99999.9999
10000 + N
(N = 0 to 99)
Position Get only -99999.9999 to 99999.9999
10100 + N
(N = 0 to 99)
Position Get only -99999.9999 to 99999.9999
10200 + N
(N = 0 to 99)
Formed angle N Get only
0 to 360
No. Data name Set/Get Data range