EasyManua.ls Logo

Omron fh-3 series - Page 265

Omron fh-3 series
904 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Scan Edge WidthFH/FZ5 Processing Item Function Reference Manual
263
2
Inspecting and Measuring
For monochrome cameras:
4 If necessary, set each item in the "Noise
removal" area.
When the measurement method is "Projection" When the measurement method is "Derivation"
Setting item
Set value
[Factory default]
Description
Measure type
[Projection]
Derivation
As the measurement type, specify either proj
ection or derivation.
Reference: "Appendixes Measurement Mechanism Edge Detection
Method" in
the "Vision System FH/FZ5 Series User's Manual (Z365)"
Density change
Absolute
(only when the
measur
ement
method is
"Derivation")
•[LightDa
rk]
•D
arkLight
Select whe
ther a black-to-white change or a white-to-black change should
be recog
nized as a density change in the specified region.
Edge Upper
Edge Lower
Position (%) for
wid
th of a density
0 to 100
[50] to [100]
Value of density
0 to 255
[20] to [255]
Select the density change level to be detected as edges.
The upper limit of edges can be set only when the measurement method
is "Derivatio
n".
Reference: "Appendixes Measurement Mechanism Edge Detection
Measureme
n
t" in the "Vision System FH/FZ5 Series User's Manual
(Z365)"
Setting item
Set value
[Factory default]
Description
Noise level
0 to 442
[5]
When detection is affected by noise, increase this value.
Reference: "Appendixes Measurement Mechanism Noise Level" in the
"V
isi
on System FH/FZ5 Series User's Manual (Z365)"
Noise width
0 to 9999
[0]
Set the width for judging noise.
When detection is affected by noise, increase this value.
Reference: "Appendixes Measurement Mechanism Noise Width" in
th
e "V
ision System FH/FZ5 Series User's Manual (Z365)"

Table of Contents

Related product manuals