BarcodeFH/FZ5 Processing Item Function Reference Manual
441
2
Inspecting and Measuring
6 If you select [GS1 DataBar] or [GS1-128] for the code type, set a group separator replacement
condition.
7 When the setting has been changed,
click [Measurement] in the "Detail" area
to verify whether measurements can be
made correctly.
8 Set up the judgement condition.
Setting item
Set value
[Factory default]
Description
Replace group
separator with specified
character string
•[Checked]
• Unchecked
If you select [GS1-128] or [GS1 Dat
aBar] for the code type, check this
checkbox to replace each group separator with another character
string.
Replacement character
stri
ng
--- Set the character string to replace group separators with.
Replacing each group separator (control character) with the
specified character string enables codes containing
group separators to be read and compared to a comparison character string.
Setting item Set value Description
Character count
0 to 1024
[1024]
Specify the character count to be judged as OK.
Verification string
Up to 1023
characters can be set.
Specify the character strings to be judged as OK.
'*' '?' is treated as
charac
ter data.
• Checked
• [Unchecked]
Checked: '*' and '?' are handled as normal characters.
Unchecked: '*' and '?' are handled as special characters.
'*': Substitution for character string (with 0 or more characters)
'?': Substitution for 1character
Integrated quality
0 to 4
[4]
Specify the integrated quality to be judged as OK.
To Next Page
Loading...
Need help?
General
