2 Parameters
2.2 List of parameters
SINAMICS G130/G150
106 List Manual (LH2), 07/2016, A5E03263479A
Dependency: Refer to: r0193
Notice: This information represents the characteristics/features of the power unit firmware. It does not provide
information/data about the characteristics/features of the hardware (e.g. bit 06 = 1 means that although the firmware
supports "liquid cooling", a power unit with liquid cooling does not have to be used).
Note: For bit 09:
The Motor Module supports the internal armature short-circuit. The function is internally required for voltage
protection (p1231 = 3).
For bit 10:
The Motor Module supports the autonomous internal voltage protection.
If the "internal voltage protection" function is activated (p1231 = 3) the Motor Module decides autonomously - using
the DC link voltage - as to whether the short-circuit is activated.
For bit 23:
The component supports the detection of current actual values (and the detection of valve close durations) with
double clocking and phase shift.
06 Liquid cooling Yes No -
07 SERVO pulse frequency changeover DDS-
dependent
Yes No -
08 Simulation mode possible Yes No -
09 Internal armature short-circuit possible Yes No -
10 Autonomous internal armature short-circuit
possible
Yes No -
11 Infeed temperature inputs X21.1/2 Yes No -
12 Integral scaled to half the gating unit clock
cycle freq.
Yes No -
13 Filtering thermal power unit current limit
possible
Yes No -
14 DC link compensation possible in power unit Yes No -
15 PT100 temperature evaluation possible Yes No -
16 Gating unit with pulse frequency
wobbulation possible
Yes No -
17 Compound braking possible Yes No -
18 Extended voltage range possible Yes No -
19 Gating unit available with current limitation
control
Yes No -
20 Component status possible Yes No -
21 Temperature evaluation via Motor Module /
CU terminals possible
Yes No -
22 Reduced device supply voltage possible Yes No -
23 Current measurement oversampling
available
Yes No -
24 Parking keeping the relevant data is
available
Yes No -
25 Internal fan operating hours counter
available
Yes No -
26 Software gating unit supported in the
Control Unit
Yes No -
27 Current controller dynamics higher Yes No -
28 Reserved -
29 Voltage measurement Yes No -
30 Gating unit with all-phase current limiting Yes No -
To Next Page
Loading...
