Siemens G130 - r2811.0 CO;BO: AND logic operation result; AND result; p2816[0...1] BI: OR logic operation inputs; OR inputs; r2817.0 CO;BO: OR logic operation result; OR result; p2822[0...3] BI: NOT logic operation input; NOT input

SINAMICS G130/G150
List Manual (LH2), 07/2016, A5E03263479A
585
2 Parameters
2.2 List of parameters
Description: Display and BICO output for the result of the AND logic operation.
Dependency: Refer to: p2810
Description: Sets the signal sources for the inputs of the OR logic operation.
Dependency: Refer to: r2817
Note: [0]: OR logic operation, input 1 --> the result is displayed in r2817.0.
[1]: OR logic operation, input 2 --> the result is displayed in r2817.0.
Description: Display and BICO output for the result of the OR logic operation.
Dependency: Refer to: p2816
Description: Sets the signal sources for the inputs of the NOT logic operations.
Index: [0] = NOT logic operation 0 input
[1] = NOT logic operation 1 input
[2] = NOT logic operation 2 input
[3] = NOT logic operation 3 input
Dependency: Refer to: r2823
Note: [0]: NOT logic operation 0 --> result is displayed in r2823.0.
[1]: NOT logic operation 1 --> result is displayed in r2823.1.
r2811.0 CO/BO: AND logic operation result / AND result
VECTOR_G Can be changed: - Calculated: - Access level: 2
Data type: Unsigned32 Dyn. index: - Func. diagram: 2634
P-Group: Functions Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 AND condition fulfilled Yes No -
p2816[0...1] BI: OR logic operation inputs / OR inputs
VECTOR_G Can be changed: T Calculated: - Access level: 2
Data type: Unsigned32 / Binary Dyn. index: - Func. diagram: 2634
P-Group: Functions Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - 0
r2817.0 CO/BO: OR logic operation result / OR result
VECTOR_G Can be changed: - Calculated: - Access level: 2
Data type: Unsigned32 Dyn. index: - Func. diagram: 2634
P-Group: Functions Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 OR condition fulfilled Yes No -
p2822[0...3] BI: NOT logic operation input / NOT input
VECTOR_G Can be changed: T Calculated: - Access level: 2
Data type: Unsigned32 / Binary Dyn. index: - Func. diagram: 2634
P-Group: Functions Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - 0