2 Parameters
2.2 List of parameters
SINAMICS G130/G150
198 List Manual (LH2), 07/2016, A5E03263479A
Description: Displays the number of relevant bits for the redundant coarse position value.
Index: [0] = Encoder 1
[1] = Encoder 2
[2] = Encoder 3
Description: Displays the number of relevant bits for the redundant coarse position value.
Description: Displays the non safety-relevant measuring steps of POS1.
Index: [0] = Encoder 1
[1] = Encoder 2
[2] = Encoder 3
Dependency: Refer to: p0416, p9513
Description: Displays the non safety-relevant measuring steps of POS1.
Dependency: Refer to: p0416, p9513
r0472[0...2] Redundant coarse position value relevant bits / Relevant bits
VECTOR_G Can be changed: - Calculated: - Access level: 3
Data type: Unsigned16 Dyn. index: - Func. diagram: -
P-Group: Encoder Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
r0472 Redundant coarse position value relevant bits / Relevant bits
ENC Can be changed: - Calculated: - Access level: 3
Data type: Unsigned16 Dyn. index: - Func. diagram: -
P-Group: Encoder Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
r0473[0...2] Non safety-relevant measuring steps position value pos1 / nsrPos1
VECTOR_G Can be changed: - Calculated: - Access level: 3
Data type: Unsigned32 Dyn. index: - Func. diagram: -
P-Group: Encoder Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
r0473 Non safety-relevant measuring steps position value pos1 / nsrPos1
ENC Can be changed: - Calculated: - Access level: 3
Data type: Unsigned32 Dyn. index: - Func. diagram: -
P-Group: Encoder Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
To Next Page
Loading...
