Siemens G130 - r0084[0...1] CO: Flux actual value; Flux act val; r0087 CO: Actual power factor; Cos phi act; r0088 CO: DC link voltage setpoint; Vdc setpoint; r0089[0...2] Actual phase voltage; U_phase act val

2 Parameters
2.2 List of parameters
SINAMICS G130/G150
70 List Manual (LH2), 07/2016, A5E03263479A
Description: Displays the flux actual value.
Index: [0] = Unsmoothed
[1] = Smoothed
Note: The flux actual value (index 1) smoothed with p1585 is only displayed for separately excited synchronous motors. In
the following cases, the unsmoothed flux actual value is also displayed:
- in the range of the current model.
- during the pole position identification.
- for I/f control.
- for a stalled drive.
Description: Displays the actual active power factor.
Description: Displays the setpoint for the DC link voltage.
Description: Displays the actual phase voltage.
Index: [0] = Phase U
[1] = Phase V
[2] = Phase W
Note: The values are determined from the transistor switch-on duration.
r0084[0...1] CO: Flux actual value / Flux act val
VECTOR_G Can be changed: - Calculated: - Access level: 3
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 6726, 6730,
6732
P-Group: Displays, signals Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r0087 CO: Actual power factor / Cos phi act
VECTOR_G Can be changed: - Calculated: - Access level: 3
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 6714, 6730,
6732, 6799
P-Group: Displays, signals Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
r0088 CO: DC link voltage setpoint / Vdc setpoint
VECTOR_G
(Tech_ctrl)
Can be changed: - Calculated: - Access level: 3
Data type: FloatingPoint32 Dyn. index: - Func. diagram: -
P-Group: Displays, signals Unit group: 5_2 Unit selection: p0505
Not for motor type: - Scaling: p2001 Expert list: 1
Min Max Factory setting
- [V] - [V] - [V]
r0089[0...2] Actual phase voltage / U_phase act val
VECTOR_G Can be changed: - Calculated: - Access level: 3
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 6719
P-Group: Displays, signals Unit group: 5_3 Unit selection: p0505
Not for motor type: - Scaling: p2001 Expert list: 1
Min Max Factory setting
- [V] - [V] - [V]