SINAMICS G130/G150
List Manual (LH2), 07/2016, A5E03263479A
197
2 Parameters
2.2 List of parameters
Description: Displays the valid bits of the redundant coarse position value.
Index: [0] = Encoder 1
[1] = Encoder 2
[2] = Encoder 3
Dependency: Refer to: p9323, p9523
Description: Displays the valid bits of the redundant coarse position value.
Dependency: Refer to: p9323, p9523
Description: Displays the number of valid bits for the fine resolution of the redundant coarse position value.
Index: [0] = Encoder 1
[1] = Encoder 2
[2] = Encoder 3
Dependency: Refer to: p9324, p9524
Description: Displays the number of valid bits for the fine resolution of the redundant coarse position value.
Dependency: Refer to: p9324, p9524
r0470[0...2] Redundant coarse position value valid bits / Valid bits
VECTOR_G Can be changed: - Calculated: - Access level: 3
Data type: Unsigned16 Dyn. index: - Func. diagram: -
P-Group: Encoder Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
r0470 Redundant coarse position value valid bits / Valid bits
ENC Can be changed: - Calculated: - Access level: 3
Data type: Unsigned16 Dyn. index: - Func. diagram: -
P-Group: Encoder Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
r0471[0...2] Redundant coarse position value fine resolution bits / Fine bit
VECTOR_G Can be changed: - Calculated: - Access level: 3
Data type: Integer16 Dyn. index: - Func. diagram: -
P-Group: Encoder Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
r0471 Redundant coarse position value fine resolution bits / Fine bit
ENC Can be changed: - Calculated: - Access level: 3
Data type: Integer16 Dyn. index: - Func. diagram: -
P-Group: Encoder Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
To Next Page
Loading...
