Siemens G130 - r8875[0...19] IF2 diagnostics telegram offset PZD receive; IF diag offs recv; r8875[0...31] IF2 diagnostics telegram offset PZD receive; IF diag offs recv

2 Parameters
2.2 List of parameters
SINAMICS G130/G150
864 List Manual (LH2), 07/2016, A5E03263479A
[2] = PZD 3
[3] = PZD 4
Note: IF2: Interface 2
Value range:
0 - 125: Bus address of the sender
255: Not assigned
Description: Displays the byte offset of the PZD in the receive telegram.
Index: [0] = PZD 1
[1] = PZD 2
[2] = PZD 3
[3] = PZD 4
[4] = PZD 5
[5] = PZD 6
[6] = PZD 7
[7] = PZD 8
[8] = PZD 9
[9] = PZD 10
[10] = PZD 11
[11] = PZD 12
[12] = PZD 13
[13] = PZD 14
[14] = PZD 15
[15] = PZD 16
[16] = PZD 17
[17] = PZD 18
[18] = PZD 19
[19] = PZD 20
Description: Displays the byte offset of the PZD in the receive telegram.
Index: [0] = PZD 1
[1] = PZD 2
[2] = PZD 3
[3] = PZD 4
[4] = PZD 5
[5] = PZD 6
[6] = PZD 7
[7] = PZD 8
[8] = PZD 9
[9] = PZD 10
[10] = PZD 11
[11] = PZD 12
[12] = PZD 13
[13] = PZD 14
[14] = PZD 15
[15] = PZD 16
r8875[0...19] IF2 diagnostics telegram offset PZD receive / IF diag offs recv
CU_G130_PN,
CU_G150_PN,
CU_G130_DP,
CU_G150_DP
Can be changed: - Calculated: - Access level: 3
Data type: Unsigned16 Dyn. index: - Func. diagram: -
P-Group: Communications Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
r8875[0...31] IF2 diagnostics telegram offset PZD receive / IF diag offs recv
VECTOR_G Can be changed: - Calculated: - Access level: 3
Data type: Unsigned16 Dyn. index: - Func. diagram: -
P-Group: Communications Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -