Siemens G130 - r0068[0...1] CO: Absolute current actual value; I_act abs val; r0068 CO: DC current in the DC link; Idc DC link; r0069[0...8] CO: Phase current actual value; I_phase act val

SINAMICS G130/G150
List Manual (LH2), 07/2016, A5E03263479A
65
2 Parameters
2.2 List of parameters
Description: Displays actual absolute current.
Index: [0] = Unsmoothed
[1] = Smoothed with p0045
Dependency: Refer to: r0027
Notice: The value is updated with the current controller sampling time.
Note: Absolute current value = sqrt(Iq^2 + Id^2)
The absolute value of the current actual value is available smoothed (r0027 with 300 ms, r0068[1] with p0045) and
unsmoothed (r0068[0]).
Description: Displays the DC current in the DC link.
Dependency: Refer to: r0027
Notice: For Basic Line Modules of chassis format, the displayed value is invalid as these units do not have any current
sensing.
Note: The DC current in the DC link is available smoothed (r0027) and unsmoothed (r0068).
Description: Display and connector output for the measured actual phase currents as peak value.
Index: [0] = Phase U
[1] = Phase V
[2] = Phase W
[3] = Phase U offset
[4] = Phase V offset
[5] = Phase W offset
[6] = Total U, V, W
[7] = Alpha component
[8] = Beta component
Note: In indices 3 ... 5, the offset currents of the 3 phases, which are added to correct the phase currents, are displayed.
The sum of the 3 corrected phase currents is displayed in index 6.
r0068[0...1] CO: Absolute current actual value / I_act abs val
VECTOR_G Can be changed: - Calculated: - Access level: 3
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 6300, 6714,
6799, 7017, 8017, 8019, 8029,
8021
P-Group: Displays, signals Unit group: 6_2 Unit selection: p0505
Not for motor type: - Scaling: p2002 Expert list: 1
Min Max Factory setting
- [Arms] - [Arms] - [Arms]
r0068 CO: DC current in the DC link / Idc DC link
B_INF Can be changed: - Calculated: - Access level: 3
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 8021, 8750
P-Group: Displays, signals Unit group: 6_4 Unit selection: p0505
Not for motor type: - Scaling: p2002 Expert list: 1
Min Max Factory setting
- [A] - [A] - [A]
r0069[0...8] CO: Phase current actual value / I_phase act val
VECTOR_G Can be changed: - Calculated: - Access level: 3
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 6730, 6731,
6732, 7983, 7987, 8850, 8950
P-Group: Displays, signals Unit group: 6_5 Unit selection: p0505
Not for motor type: - Scaling: p2002 Expert list: 1
Min Max Factory setting
- [A] - [A] - [A]