Siemens G130 - p4641[0...2] OEM encoder diagnostic signal selection; OEM enc diag sel; p4642 Test function encoder fault; Test encoder fault; p4650 Encoder functional reserve component number; Enc fct_res num; r4651[0...3] Encoder functional reserve; Enc fct_reserve

2 Parameters
2.2 List of parameters
SINAMICS G130/G150
686 List Manual (LH2), 07/2016, A5E03263479A
Description: Sets the trace functionality for OEM encoder manufacturers.
Index: [0] = Encoder 1
[1] = Encoder 2
[2] = Encoder 3
Description: Test function to initiate an encoder fault
For a 0/1 transition, an encoder fault is output at the currently used motor encoder.
For a 1/0 transition and an alarm acknowledgment, the encoder fault that was issued is cleared.
Notice: It is not permissible that a data set is switched over between issuing and deleting an encoder fault.
Description: Sets the component number (p0141) of the encoder whose functional reserve is to be displayed (r4651).
Dependency: Refer to: r4651
Description: Displays the functional reserve of the encoder selected via p4650.
0 ... 25 %:
The function limit has been reached. A service is recommended.
26 ... 100 %:
The encoder is working in the specified range.
Index: [0] = Function reserve 1
[1] = Function reserve 2
[2] = Function reserve 3
[3] = Function reserve 4
Dependency: Refer to: p4650
p4641[0...2] OEM encoder diagnostic signal selection / OEM enc diag sel
VECTOR_G Can be changed: U, T Calculated: - Access level: 3
Data type: Unsigned16 Dyn. index: - Func. diagram: -
P-Group: Encoder Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 65535 0
p4642 Test function encoder fault / Test encoder fault
VECTOR_G Can be changed: U, T Calculated: - Access level: 3
Data type: Unsigned8 Dyn. index: - Func. diagram: -
P-Group: Encoder Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 255 0
p4650 Encoder functional reserve component number / Enc fct_res num
CU_G130_PN,
CU_G150_PN,
CU_G130_DP,
CU_G150_DP
Can be changed: U, T Calculated: - Access level: 3
Data type: Unsigned16 Dyn. index: - Func. diagram: -
P-Group: Displays, signals Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 399 0
r4651[0...3] Encoder functional reserve / Enc fct_reserve
CU_G130_PN,
CU_G150_PN,
CU_G130_DP,
CU_G150_DP
Can be changed: - Calculated: - Access level: 3
Data type: FloatingPoint32 Dyn. index: - Func. diagram: -
P-Group: Displays, signals Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]