Siemens G130 - p9671[0...n] SI module identifier Motor Module; Module ID MM; p9672 SI module identifier Power Module; Module ID PM; p9673 SI module identifier Sensor Module channel 1; Module ID SM 1; p9674 SI module identifier Sensor Module channel 2; Module ID SM 2

SINAMICS G130/G150
List Manual (LH2), 07/2016, A5E03263479A
971
2 Parameters
2.2 List of parameters
Description: CRC via the Node Identifier of a Motor Module.
Note: The CRC is saved indexed when Motor Modules are connected in parallel.
MM: Motor Module
Description: CRC via the Node Identifier of a Power Module.
Note: PM: Power Module
Description: CRC via Node Identifier of the Sensor Module, which is used by the first monitoring channel.
Note: SM: Sensor Module
Description: CRC via Node Identifier of the Sensor Module, which is used by the second monitoring channel.
Note: SM: Sensor Module
Description: CRC via the serial number of the encoder, which is used by the first monitoring channel.
Note: When using an encoder without its own serial number, the value of zero is kept.
p9671[0...n] SI module identifier Motor Module / Module ID MM
VECTOR_G Can be changed: C2(95), T Calculated: - Access level: 3
Data type: Unsigned32 Dyn. index: PDS, p0120 Func. diagram: -
P-Group: Safety Integrated Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 4294967295 0
p9672 SI module identifier Power Module / Module ID PM
VECTOR_G Can be changed: C2(95), T Calculated: - Access level: 3
Data type: Unsigned32 Dyn. index: - Func. diagram: -
P-Group: Safety Integrated Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 4294967295 0
p9673 SI module identifier Sensor Module channel 1 / Module ID SM 1
VECTOR_G Can be changed: C2(95), T Calculated: - Access level: 3
Data type: Unsigned32 Dyn. index: - Func. diagram: -
P-Group: Safety Integrated Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 4294967295 0
p9674 SI module identifier Sensor Module channel 2 / Module ID SM 2
VECTOR_G Can be changed: C2(95), T Calculated: - Access level: 3
Data type: Unsigned32 Dyn. index: - Func. diagram: -
P-Group: Safety Integrated Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 4294967295 0
p9675 SI module identifier sensor channel 1 / Module ID sensor 1
VECTOR_G Can be changed: C2(95), T Calculated: - Access level: 3
Data type: Unsigned32 Dyn. index: - Func. diagram: -
P-Group: Safety Integrated Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 4294967295 0