Siemens G130 - D; E; F

SINAMICS G130/G150
List Manual (LH2), 07/2016, A5E03263479A
1967
Index
D
Data Set, 24
Command data set, CDS, 24
Drive Data Set, DDS, 24
Encoder Data Set, EDS, 24
Motor Data Set, MDS, 24
Power unit Data Set, PDS, 24
Data set, 24
Data sets, 1305
Command data set, 24
Drive data set, 24
Encoder data set, 24
Motor data set, 24
Power unit data set, 24
Data type (parameter, signal source), 23
DCBRK, 1358
DDS, (Drive Data Set), 1305, 1307
DDS, drive data set, 24
Dependency (parameter), 29
Description (parameter), 28
Digital inputs
Control Unit 320-2 (CU320-2), 1106
Terminal Board 30 (TB30), 1319
Terminal Module 31 (TM31), 1332
Digital inputs/outputs
Control Unit 320-2 (CU320-2), 1106
Terminal Module 31 (TM31), 1332
Digital outputs
Control Unit 320-2 (CU320-2), 1106
Terminal Board 30 (TB30), 1319
Terminal Module 31 (TM31), 1332
Direction limitation, 1226
Direction reversal, 1226
Directory
ASCII table, 1942
Complete table of contents, 9
Index, 1961
List of abbreviations, 1945
References, 1954
Table of contents, function diagrams, 1093
Display
Alarms, 1356
Faults, 1356
Display parameters, 17
DO, Drive Object, 18
Drive data sets, 1305
Drive object, 18
DSC (Dynamic Servo Control), 1226
E
EDS, (Encoder Data Set), 24, 1305, 1308
ENCODER, 1358
Encoder data sets, 1305
Encoder evaluation, 1236
Essential service mode (ESM), 1277
Expert list, 28
Explanations
on function diagrams, 1101
F
Factory setting, 27
Fault
Acknowledgment, 1359, 1366
Cause, 1366
Component, 1365
Display, 1356
Drive object, 1365
Explanation of list, 1361
Fault location, 1362
Fault reaction, 1357, 1366
General information, 1356
How to distinguish a fault from an alarm, 1356
List of all faults, 1369
Message class, 1362
Message value, 1362
Name, 1362
Number, 1361
Number range, 1367
Propagation, 1365
Remedy, 1366
Save when switching off, 1359
Fault buffer, 1296
Configuration, 1297, 1298
Save when switching off, 1359
Fault value, 1366
Faults/alarms configuring, 1296
Faults/alarms triggering (r2129), 1296
Fixed speed setpoints, 1226
Fixed values, 1103, 1279, 1280
Free interconnection via BICO, 1122
Free interconnection, status words, 1153, 1158
Friction characteristic, 1272
Function (parameter), 28
Function diagrams, Basic Infeed
Control word,
sequence control infeed, 1313
Interface to the Basic Infeed power unit (control
signals, actual values), 1317
Missing enables, line contactor control, 1316
Overview, 1312
Sequencer, 1315
Signals and monitoring functions (p3400 = 0), 1318
Status word,
sequence control infeed, 1314
Function diagrams, Basic Operator Panel 20 (BOP20)
Control word BOP20 interconnection, 1354