Siemens G130 - F01057 CU: Internal error (different DRIVE-CLiQ type for the slave); F01058 CU: Internal error (slave missing in topology); F01059 CU: Internal error (port does not exist)

SINAMICS G130/G150
List Manual (LH2), 07/2016, A5E03263479A
1385
4 Faults and alarms
4.2 List of faults and alarms
Note:
Only for internal Siemens troubleshooting.
Remedy: Contact Technical Support.
F01057 CU: Internal error (different DRIVE-CLiQ type for the slave)
Message value: %1
Message class: Hardware/software error (1)
Drive object: B_INF, TM150, VECTOR_G
Component: Control Unit (CU) Propagation: DRIVE
Reaction: NONE
Acknowledge: IMMEDIATELY
Cause: The requested DRIVE-CLiQ type (hps_ps, hps_enc, ...) has been specified differently for the same slave component.
Fault value (r0949, interpret hexadecimal):
Method ID.
Note:
Only for internal Siemens troubleshooting.
Remedy: Contact Technical Support.
F01058 CU: Internal error (slave missing in topology)
Message value: %1
Message class: Hardware/software error (1)
Drive object: B_INF, TM150, VECTOR_G
Component: Control Unit (CU) Propagation: DRIVE
Reaction: NONE
Acknowledge: IMMEDIATELY
Cause: The requested slave component does not exist in the topology.
Fault value (r0949, interpret hexadecimal):
Method ID.
Note:
Only for internal Siemens troubleshooting.
Remedy: Contact Technical Support.
F01059 CU: Internal error (port does not exist)
Message value: %1
Message class: Hardware/software error (1)
Drive object: B_INF, TM150, VECTOR_G
Component: Control Unit (CU) Propagation: DRIVE
Reaction: NONE
Acknowledge: IMMEDIATELY
Cause: The port object assigned according to the topology of the requested slave component does not exist.
Fault value (r0949, interpret hexadecimal):
Method ID.
Note:
Only for internal Siemens troubleshooting.
Remedy: Contact Technical Support.