Siemens G130 - r8894.0...15 BO: IF2 connector-binector converter binector output; Con;bin outp; r8895.0...15 BO: IF2 connector-binector converter binector output; Con;bin outp

To Next Page

To Previous Page

2 Parameters

2.2 List of parameters

SINAMICS G130/G150

874 List Manual (LH2), 07/2016, A5E03263479A

Dependency: Refer to: r8850

Note: IF2: Interface 2

Description: Binector output for bit-serial interconnection of a PZD word received via interface 2.

The PZD is selected via p8899[0].

Dependency: Refer to: p8899

Description: Binector output for bit-serial interconnection of a PZD word received via interface 2.

The PZD is selected via p8899[1].

11 Bit 11 ON OFF -

12 Bit 12 ON OFF -

13 Bit 13 ON OFF -

14 Bit 14 ON OFF -

15 Bit 15 ON OFF -

r8894.0...15 BO: IF2 connector-binector converter binector output / Con/bin outp

CU_G130_PN,

CU_G150_PN,

CU_G130_DP,

CU_G150_DP,

VECTOR_G, B_INF,

TM31, TM120, TM150,

ENC

Can be changed: - Calculated: - Access level: 3

Data type: Unsigned16 Dyn. index: - Func. diagram: 2485, 2491

P-Group: Communications Unit group: - Unit selection: -

Not for motor type: - Scaling: - Expert list: 1

Min Max Factory setting

- - -

Bit field: Bit Signal name 1 signal 0 signal FP

00 Bit 0 ON OFF -

01 Bit 1 ON OFF -

02 Bit 2 ON OFF -

03 Bit 3 ON OFF -

04 Bit 4 ON OFF -

05 Bit 5 ON OFF -

06 Bit 6 ON OFF -

07 Bit 7 ON OFF -

08 Bit 8 ON OFF -

09 Bit 9 ON OFF -

10 Bit 10 ON OFF -