2 Parameters
2.2 List of parameters
SINAMICS G130/G150
588 List Manual (LH2), 07/2016, A5E03263479A
Description: Sets the mode for the time stamp
Value: 0: Operating hours
1: UTC format
2: Operating hours + 01.01.2000
Notice: For p3100 = 1:
The system prevents this setting from being changed. The parameter can only be influenced after "Set factory
setting" or with a "Project download".
Note: RTC: Real-time clock
UTC: Universal Time Coordinates
For p3100 = 1:
Time of day synchronization is only possible with this setting.
The UTC time started, according to the definition on 01.01.1970 at 00:00:00 and is output in days and milliseconds.
Description: Setting the UTC time.
This means that the drive system is synchronized to the time specified by the time master.
To start p3101[1] must be written to followed by p3101[0]. After writing to p3101[0], the UTC time is accepted.
Index: [0] = Milliseconds
[1] = Days
Dependency: Refer to: p3100
Description: Displaying the current UTC time.
Index: [0] = Milliseconds
[1] = Days
Dependency: Refer to: p3100
p3100 RTC time stamp mode / RTC t_stamp mode
CU_G130_PN,
CU_G150_PN,
CU_G130_DP,
CU_G150_DP
Can be changed: U, T Calculated: - Access level: 3
Data type: Unsigned16 Dyn. index: - Func. diagram: -
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 2 2
p3101[0...1] Setting UTC time / Set UTC time
CU_G130_PN,
CU_G150_PN,
CU_G130_DP,
CU_G150_DP
Can be changed: U, T Calculated: - Access level: 3
Data type: Unsigned32 Dyn. index: - Func. diagram: -
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 4294967295 0
r3102[0...1] Displaying UTC time / Display UTC time
CU_G130_PN,
CU_G150_PN,
CU_G130_DP,
CU_G150_DP
Can be changed: - Calculated: - Access level: 3
Data type: Unsigned32 Dyn. index: - Func. diagram: -
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
To Next Page
Loading...
