Command Manual – ARP
H3C S7500E Series Ethernet Switches Chapter 1 ARP Configuration Commands
1-4
Description
Use the display arp command to display ARP entries in the ARP mapping table.
Related commands: arp static, reset arp.
Examples
# Display the information of all ARP entries.
<Sysname> display arp all
Type: S-Static D-Dynamic
IP Address MAC Address VLAN ID Interface Aging Type
20.1.1.1 000f-e200-0001 N/A N/A N/A S
193.1.1.70 00e0-fe50-6503 100 GE2/0/1 DIS D
192.168.0.115 000d-88f7-9f7d 1 GE2/0/2 DIS D
192.168.0.39 0012-a990-2241 1 GE2/0/3 DIS D
Table 1-1 Description on the fields of the display arp command
Field Description
IP Address IP address in an ARP entry
MAC Address MAC address in an ARP entry
VLAN ID VLAN ID contained a static ARP entry
Interface Outbound port in an ARP entry
Aging
Aging time for a dynamic ARP entry in minutes. “DIS” means
the ARP entry is learned from an interface board.
Type ARP entry type: D stands for dynamic and S for static.
# Display the number of all ARP entries
<Sysname> display arp all count
Total Entry(ies): 4
1.1.5 display arp ip-address
Syntax
display arp ip-address [ slot slot-id ] [ verbose ] [ | { begin | exclude | include } string ]
View
Any view
Parameters
ip-address: Displays the ARP entry for the specified IP address.
slot slot-id: Displays the ARP entry for the specified slot.