H3C S7500E Series Command Manual

Command Manual – IP Routing Overview
H3C S7500E Series Ethernet Switches Chapter 1 Routing Overview Commands
1-8
1.1.4 display ip routing-table acl
Syntax
display ip routing-table acl acl-number [ verbose ]
View
Any view
Parameters
acl-number: Basic ACL number, in the range of 2000 to 2999.
verbose: Displays detailed routing table information, including that for inactive routes.
With this argument absent, the command displays only brief information about active
routes.
Description
Use the display ip routing-table acl command to display information about routes
permitted by a specified basic ACL.
This command is intended for the follow-up display of routing policies.
For more information about routing policy, refer to IPv4 Routing Configuration.
 Note:
If the specified ACL does not exist or it has no rules configured, the entire routing table
is displayed.
Examples
# Define basic ACL 2000 and set the route filtering rules.
<Sysname > system-view
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule permit source 192.168.0.0 0.0.255.255
[Sysname-acl-basic-2000] rule deny source any
# Display brief information about active routes permitted by basic ACL 2000.
[Sysname-acl-basic-2000] display ip routing-table acl 2000
Routes Matched by Access list : 2000
Summary Count : 2
Destination/Mask Proto Pre Cost NextHop Interface

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English