H3C S7500E Series Command Manual

Command Manual – HA
H3C S7500E Series Ethernet Switches Chapter 1 VRRP Configuration Commands
1-18
Field Description
Version Errors Total number of packets with version errors
VRID Errors Total number of packets with VRID errors
1.2.3 reset vrrp ipv6 statistics
Syntax
reset vrrp ipv6 statistics [ interface interface-type interface-number [ vrid
virtual-router-id ] ]
View
User view
Parameters
interface interface-type interface-number: Clears VRRP statistics of a specific
interface. interface-type interface-number specifies an interface by its type and number.
vrid virtual-router-id: Clears VRRP statistics of the specified standby group.
virtual-router-id specifies a standby group by its group number, in the range 1 to 255.
Description
Use the reset vrrp ipv6 statistics command to clear VRRP statistics.
If you specify both the interface and standby group, the statistics about the specified
standby group on the specified interface are cleared; if you specify only the interface,
the statistics about all the standby groups on the interface are cleared; if you specify
neither, the statistics about all the standby groups on the device are cleared.
Examples
# Clear the statistics about all the standby groups on the device.
<Sysname> reset vrrp ipv6 statistics
1.2.4 vrrp ipv6 vrid authentication-mode
Syntax
vrrp ipv6 vrid virtual-router-id authentication-mode simple key
undo vrrp ipv6 vrid virtual-router-id authentication-mode
View
Interface view

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English