Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches
Chapter 2 IPv6 RIPng Configuration
Commands
2-12
Description
Use the ripng command to create a RIPng process and enter RIPng view.
Use the undo ripng command to disable a RIPng process.
By default, no RIPng process is enabled.
Examples
# Create RIPng process 100 and enter its view.
<Sysname> system-view
[Sysname] ripng 100
[Sysname-ripng-100]
# Disable RIPng process 100.
[Sysname] undo ripng 100
2.1.13 ripng default-route
Syntax
ripng default-route { only | originate } [ cost cost ]
undo ripng default-route
View
Interface view
Parameters
only: Indicates that only the IPv6 default route (::/0) is advertised via the interface.
originate: Indicates that the IPv6 default route (::/0) is advertised without suppressing
other routes.
cost: Metric of the advertised default route, in the range of 1 to 15, with a default value
of 1.
Description
Use the ripng default-route command to advertise a default route with the specified
routing metric to a RIPng neighbor.
Use the undo ripng default-route command to stop advertising and forwarding the
default route.
By default, a RIP process does not advertise any default route.
After you execute this command, the generated RIPng default route is advertised in a
route update over the specified interface. This IPv6 default route is advertised without
considering whether it already exists in local IPv6 routing table.
To Next Page
Loading...
Need help?
General
