H3C S7500E Series Command Manual

Command Manual – Multicast
H3C S7500E Series Ethernet Switches Chapter 5 MSDP Configuration Commands
5-14
View
MSDP view
Parameters
peer-address: MSDP peer address.
ttl-value: Time-to-Live (TTL) value, in the range of 0 to 255.
Description
Use the peer minimum-ttl command to configure the minimum TTL value of multicast
packets encapsulated in SA messages.
Use the undo peer minimum-ttl command to restore the default setting.
By default, the minimum TTL value of a multicast packet encapsulated in an SA
message is 0.
Related commands: display msdp peer-status.
Examples
# Set the minimum TTL value of multicast packets to be encapsulated in SA messages
to 10 so that only multicast packets whose TTL value is larger than or equal to 10 can
be forwarded to the MSDP peer 110.10.10.1.
<Sysname> system-view
[Sysname] msdp
[Sysname-msdp] peer 110.10.10.1 minimum-ttl 10
5.1.14 peer request-sa-enable
Syntax
peer peer-address request-sa-enable
undo peer peer-address request-sa-enable
View
MSDP view
Parameters
peer-address: MSDP peer address.
Description
Use the peer request-sa-enable command to enable the device to send SA request
messages.
Use the undo peer request-sa-enable command to disable the device from sending
SA request messages.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English