Command Manual – HA
H3C S7500E Series Ethernet Switches Chapter 1 VRRP Configuration Commands
1-5
Field Description
Auth Failures Number of packets with authentication failures
Invalid Auth Type
Number of packets with authentication failures due
to invalid authentication types
Auth Type Mismatch
Number of packets with authentication failures due
to mismatching authentication types
Packet Length Errors Number of packets with VRRP packet length errors
Address List Errors
Number of packets with virtual IP address list
errors
Become Master
Number of times that the switch worked as the
master
Priority Zero Pkts Rcvd
Number of received advertisements with the
priority of 0
Advertise Rcvd Number of received advertisements
Advertise Sent Number of advertisements sent
Global statistics Statistics about all standby groups
CheckSum Errors Total number of packets with checksum errors
Version Errors Total number of packets with version errors
VRID Errors Total number of packets with VRID errors
1.1.3 reset vrrp statistics
Syntax
reset vrrp statistics [ interface interface-type interface-number [ vrid
virtual-router-id ] ]
View
User view
Parameters
interface interface-type interface-number: Clears VRRP statistics of a specified
interface. interface-type interface-number specifies an interface by its type and number.
vrid virtual-router-id: Clears VRRP statistics of the specified standby group.
virtual-router-id specifies a standby group by its group number, in the range 1 to 255.
Description
Use the reset vrrp statistics command to clear VRRP statistics.
To Next Page
Loading...
Need help?
General
