H3C S7500E Series

Command Manual – HA
H3C S7500E Series Ethernet Switches Chapter 2 HA Configuration Commands
2-4
View
System view
Parameters
None
Description
Use the slave switchover command to manually configure the switchover between the
AMB and SMB.
Related commands: slave switchover { enable | disable }.
Examples
# Manually configure the switchover between the AMB and the SMB.
<Sysname> system-view
[Sysname] slave switchover
Caution!!! Confirm switch slave to master?[Y/N] y
Starting.....
RAM Line....OK
2.1.6 slave switchover { enable | disable }
Syntax
slave switchover { enable | disable }
View
System view
Parameters
enable: Enables manual configuration of the switchover between AMB and SMB.
disable: Disables manual configuration of the switchover between AMB and SMB.
Description
Use the slave switchover { enable | disable } command to configure manual
switchover function between AMB and SMB.
By default, manual configuration of the switchover between AMB and SMB is enabled.
Related commands: slave switchover.
Examples
# Enable manual configuration of the switchover between AMB and SMB.
<Sysname> system-view