Command Manual – AAA RADIUS HWTACACS
H3C S7500E Series Ethernet Switches
Chapter 1 AAA/RADIUS/HWTACACS
Configuration Commands
1-63
Parameters
hwtacacs-scheme hwtacacs-scheme-name: Specifies a HWTACACS scheme by its
name, a string of 1 to 32 characters.
slot slot-number: Specifies the slot where the interface card is inserted.
Description
Use the display stop-accounting-buffer command to display information about the
stop-accounting requests buffered in the device by scheme, session ID, time range,
user name, or slot.
Related commands: reset stop-accounting-buffer, stop-accounting-buffer enable,
retry stop-accounting.
Examples
# Display information about the buffered stop-accounting requests for HWTACACS
scheme hwt1.
<Sysname> display stop-accounting-buffer hwtacacs-scheme hwt1
Total 0 record(s) Matched
1.3.4 hwtacacs nas-ip
Syntax
hwtacacs nas-ip ip-address
undo hwtacacs nas-ip
View
System view
Parameters
ip-address: IP address in dotted decimal notation. It must be an address of the device
and cannot be all 0s address, all 1s address, a class D address, a class E address or a
loopback address.
Description
Use the hwtacacs nas-ip command to set the IP address for the device to use as the
source address of the HWTACACS packets to be sent to the server.
Use the undo hwtacacs nas-ip command to remove the configuration.
By default, the source IP address of a packet sent to the server is the IP address of the
outbound port.
Note that:
To Next Page
Loading...
Need help?
General
