H3C S7500E Series

Command Manual – Portal
H3C S7500E Series Ethernet Switches Chapter 1 Portal Configuration Commands
1-18
Note that the portal server to be referenced must exist.
Related commands: display portal server.
Examples
# Enable portal authentication on interface VLAN-interface 100, setting the portal
server to pts, the authentication mode to direct.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname–Vlan-interface100] portal server pts method direct
1.1.14 reset portal connection statistics
Syntax
reset portal connection statistics { all | interface interface-type interface-number }
View
User view
Parameters
all: Specifies all interfaces.
interface interface-type interface-number: Specifies an interface by its type and
number.
Description
Use the reset portal connection statistics command to clear portal connection
statistics on a specified interface or all interfaces.
Examples
# Clear portal connection statistics on interface Vlan-interface 2.
<Sysname> reset portal connection statistics interface Vlan-interface 2
1.1.15 reset portal server statistics
Syntax
reset portal server statistics { all | interface interface-type interface-number }
View
User view
Parameters
all: Specifies all interfaces.