H3C S7500E Series

Command Manual – PoE
H3C S7500E Series Ethernet Switches Chapter 1 PoE Configuration Commands
1-27
View
System view
Parameters
pse-id: PSE ID.
Description
Use the poe enable pse command to enable PoE for the PSE.
Use the undo poe enable pse command to disable PoE for the PSE.
By default, PoE is disabled for the PSE.
Examples
# Enable PoE for PSE 7.
<Sysname> system-view
[Sysname] poe enable pse 7
1.1.20 poe legacy enable
Syntax
poe legacy enable [ pse pse-id ]
undo poe legacy enable [ pse pse-id ]
View
System view
Parameters
pse pse-id: Specifies a PSE ID.
Description
Use the poe legacy enable command to enable the PSE to detect nonstandard PDs.
Use the undo poe legacy enable command to disable the PSE from detecting
nonstandard PDs.
By default, the PSE is disabled from detecting nonstandard PDs.
Examples
# Enable PSE 7 to detect nonstandard PDs.
<Sysname> system-view
[Sysname] poe legacy enable pse 7