H3C S7500E Series Command Manual

Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 6 Routing Policy Configuration Commands
6-1
Chapter 6 Routing Policy Configuration
Commands
 Note:
At present, the LSQ1GP12EA boards in the S7500E series do not support IPv6.
6.1 Routing Policy Common Configuration Commands
Refer to IPv4 routing commands for routing policy common configuration commands.
6.2 IPv6 Routing Policy Configuration Commands
6.2.1 apply ipv6 next-hop
Syntax
apply ipv6 next-hop ipv6-address
undo apply ipv6 next-hop
View
Routing policy view
Parameters
ipv6-address: Next hop IPv6 address.
Description
Use the apply ipv6 next-hop command to apply a next hop to IPv6 routes.
Use the undo apply ipv6 next-hop command to remove the clause configuration.
No next hop address is set for IPv6 routing information by default.
Using the apply ipv6 next-hop command to set a next hop when redistributing routes
does not take effect.
Examples
# Create routing policy policy1 with node 10, matching mode permit. If a route
matches AS path list 1, set next hop 3ff3:506::1 for it.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English