Command Manual – IP Addressing and Performance
H3C S7500E Series Ethernet Switches
Chapter 2 IP Performance Configuration
Commands
2-4
longer: Displays FIB entries that match the specified address/mask and have masks
longer than or equal to the mask that a user enters. If no masks are specified, FIB
entries that match the natural network address and have the masks longer than or
equal to the natural mask will be displayed.
Description
Use the display fib ip-address command to display FIB entries that match the
specified destination IP address.
Examples
# Display the FIB entries that match the natural network of 10.1.0.0 and have the masks
longer than or equal to the natural mask.
<Sysname> display fib 10.1.0.0 longer
Route Entry Count: 2
Flag:
U:Useable G:Gateway H:Host B:Blackhole D:Dynamic S:Static
R:Reject L:Generated by ARP or ESIS
Destination/Mask Nexthop Flag TimeStamp Interface Token
10.0.0.0/8 0.0.0.0 U t[1141140133] Vlan1 invalid
10.1.1.1/32 127.0.0.1 HU t[1141140133] InLoop0 invalid
For description about the above output, refer to Table 2-1.
2.1.3 display fib statistics
Syntax
display fib statistics
View
Any view
Parameters
None
Description
Use the display fib statistics command to display statistics about the FIB entries.
Examples
# View statistics about the FIB entries.
<Sysname> display fib statistics
Route Entry Count : 2
To Next Page
Loading...
Need help?
General
